When operating a car jack without using chocks, the side skirt of the vehicle may bend. The vehicle may become unstable and this could result in injuries to the user.

The amount of nickel released by the silver-coloured, angular beads is too high (measured value 27.5 µg/cm²/week). Nickel is a strong sensitizer and can cause allergic reactions if present in articles that come into direct and prolonged contact with the skin. The product does not comply with the REACH Regulation.

The back-up cable supplying current to the ignition switch might not be connected properly. If this additional power supply is not available, it means that, in the event of failure of the main battery after the engine is switched off, neither the electronic parking brake nor the "P" transmission position would activate and the vehicle could start rolling on its own.

Direct access to the saw blade while the cutter is in operation poses an acute danger of injury through the loss of limbs, for example. A similar situation also pertains with regard to access to various other machine parts. The product does not comply with the requirements of the Machinery Directive.

More than 30% of the particles in the powder are small enough to get into the pulmonary alveoli and it contains talc which should be kept away from nose and mouth of children under 3 years of age. In addition, the powder contains the dye CI 42535 which can cause serious eye damage and is harmful if ingested and it is contaminated by aerobic mesophilic bacteria (measured value 19000 cfu/g).

Due to an incorrect translation of the label, the French version of the label gives misleading information to consumers stating that babies and small children should be exposed to direct sunlight instead of the correct statement 'Babies and small children should not be exposed to direct sunlight'. This can potentially result in children and babies being excessively exposed to sunlight. The product does not comply with the Cosmetic Products Regulation.

The ignition lock may be damaged by engine-generated vibration and cause the engine to stall unexpectedly. If this happens in traffic it could lead to an accident.

Defective nuts may have been fitted to the track rod joint on the wheel bearing of the rear axle and might not maintain the requisite pre-tensioning force. Loosening of the joint may result in reduced control of the vehicle and an increased accident risk.

The product contains nickel (measured value 24 mg/kg). Nickel can cause skin irritation and induce sensitisation or elicit allergic responses. The Council of Europe Resolution ResAP (2008)1 on requirements and criteria for the safety of tattoos and permanent make-up, recommends that the content of nickel in inks for permanent make-up be as low as technically achievable. The product does not comply with the national legislation.

At high vehicle speed, combined with strong wind, the plastic front service hatch (located between the windscreen and headlights) can detach from the vehicle and fall into the traffic area.