The electrical insulation of the battery charger is not sufficient. The creepage distance between the primary and secondary circuits is too small. The product does not comply with the requirements of the Low Voltage Directive and the relevant European standard EN 60335.

The electrical insulation of the power supply unit is not sufficient. The creepage distance between the primary and secondary circuits is too small. The product does not comply with the requirements of the Low Voltage Directive and the relevant European standards EN 60598 and EN 61347.

The casing of the product does not have sufficient mechanical strength which could lead to live parts becoming accessible. It is possible to touch the live parts of pins of the plug when inserting or removing the device from the mains socket. The product does not comply with the requirements of the Low Voltage Directive and the relevant European standard EN 60335.

The insulation between the primary and secondary circuits is not sufficient, which may cause an electric shock. The product does not comply with the requirements of the Low Voltage Directive and the relevant European standard EN 60950.

Live parts become accessible when a different sized light bulb is used in the lamp holder. In addition, the clearance between the accessible parts and the lateral contacts of the lamp holder is too small. The product does not comply with the requirements of the Low Voltage Directive and the relevant European standard EN 60598.

The cables are not properly secured against pulling and twisting and the wire ends can be pulled out easily. The PVC cables do not protect properly against the penetration of water. As a result of these defects, the user could touch live parts during normal use. The product does not comply with the requirements of the Low Voltage Directive and the relevant European standard EN 60598.

There is no earth conductor which could lead to a risk of electric shock if an appliance which should be earthed was connected.

The internal earth lead is not adequately attached to the body, resulting in inadequate protection from electric shock. The product does not comply with the requirements of the Low Voltage Directive and the relevant European standard EN 60335.

Internal wires are are only soldered and not attached mechanically. The windings on the transformer are touching. The metal parts of the bulb may become live as a consequence, leading to the user receiving an electrical shock if the bulb is touched. The product does not comply with the requirements of the Low Voltage Directive and the relevant European standards EN 62560 and EN 62471.

The pins of the built-in plug and plug adapter do not have an insulating collar. The plug adapter allows single-pole insertion of a plug, leaving the remaining free live pin accessible. The cover for the LED can be removed by hand during charging, leaving live parts accessible. The cross-sectional area of the core of the wires is insufficient: in case of a short circuit the wires may overheat and can cause a fire. The heat and flame resistance of the insulating material that hold the pins of the built-in plug in position is insufficient.