The adaptor may overheat, causing burns, and parts may become deformed, leaving live parts accessible which could result in an electric shock. The product does not comply with the relevant national standard UNE 20315.

Live parts are accessible as the holes for the plug pins are not protected by shutters. The product does not comply with the relevant national standard.

The insulation of the product is not adequate and the power supply is not protected against moisture, although the product is recommended for outdoor use. The product does not comply with the requirements of the Low Voltage Directive and the relevant European standard EN 60598.

One pin of a plug can be inserted leaving the other live pin accessible. The product does not comply with the relevant national standard.

The product is not earthed and could become live in the event of a fault with the insulation. The dimensions of the plug pins are not correct and the user could consequently touch live parts. The product does not comply with the requirements of the Low Voltage Directive and the relevant European standard EN 60598 and the relevant national standard BS1363.

The cable can overheat which could lead to a fire. The product does not comply with the requirements of the Low Voltage Directive and the relevant European standard EN 60598.

The product poses a risk of electric shock for the following reasons. Firstly, the dimensions of the plug are substantially less than required. Secondly, the wire ends soldered to the terminals of the flashing unit and the LEDs are not adequately protected against pulling and twisting. Thirdly, the accessible basic insulated wires can come into contact with sharp edges of the flashing switch and control unit. Finally, the insulation provided by the shrink tubing for the lamps is inadequate.

The dimensions of the plug are too small and the wire ends soldered to the terminals of the flashing unit and the LED are not adequately protected against pulling and twisting. The accessible, basic insulated, wires can come into contact with sharp edges of the flashing switch and control unit. The cross-sectional area of the external and internal wires is too small and the wires could overheat and cause a fire. The product does not comply with the requirements of the Low Voltage Directive and the relevant European standard EN 60598.

The creepage distances and insulation clearances between the primary and secondary circuits are too small. This can lead to the user receiving an electric shock from parts becoming live. Moreover, the cables are not sufficiently resistant and can sever, possibly causing a fire. The product does not comply with the requirements of the Low Voltage Directive and the relevant European standards EN 60598 and EN 61558.

The product is not protected against moisture but is recommended for outdoor use. The insulation of the cable is not adequate. The product does not comply with the requirements of the Low Voltage Directive and the relevant European standard EN 60598.