The ball included in the set contains dibutylphthalate (DBP) (measured value 0.16 % by weight). This phthalate may harm the health of children, causing possible damage to the reproductive system. According to the REACH Regulation the phthalates DEHP, DBP and BBP are prohibited in all toys and childcare articles.

The LED light is too powerful and may cause damage to sight. The product does not comply with the requirements of the Toy Safety Directive and the relevant European Standard EN 62115.

An inadequate screw connection may result in the loss of the side panel, endangering following road-users if this side panel falls on the roadway.

The amount of lead in the soldering of the USB cable is too high (measured value: 26%). This may pose a risk to the environment in the disposal of the product. The product does not comply with the requirements of the Directive 2011/65/EU on the restriction of the use of certain hazardous substances in electrical and electronic equipment (RoHS 2).

The hook in the bonnet safety system may not engage with the safety lock pin of the bonnet lock system. The bonnet may not close properly and may unexpectedly open while driving.

The product is not protected against moisture but is recommended for outdoor use. The product does not comply with the Low Voltage Directive and the relevant European standard EN 60598.

The shaft of the steering column could break leading to a loss of steering control and the risk of an accident.

In the event of an ignition misfire, unburned fuel can be routed into the exhaust system, which can cause high exhaust temperatures that may pose a fire hazard.

The routing of the starter motor cable may be incorrect, causing cable chafing, arcing and short circuit. This may result in the vehicle stalling, melting of the starter motor cable sheathing and surrounding parts and in extreme circumstances an under-bonnet fire.

The insulation between the primary and secondary windings of the transformer is insufficient and there is a high likelihood of flashover occurring. If flashover occurs, there will be mains voltage on the exposed metal parts for charging the batteries. That means people might get an electric shock if they touch the metal parts. Also, if there are batteries in the charger at the time, the batteries might act violently to the high voltage leading to the risk of a fire.