Live parts become accessible when a different sized light bulb is used in the lamp holder. In addition, the clearance between the accessible parts and the lateral contacts of the lamp holder is too small. The product does not comply with the requirements of the Low Voltage Directive and the relevant European standard EN 60598.

The cables are not properly secured against pulling and twisting and the wire ends can be pulled out easily. The PVC cables do not protect properly against the penetration of water. As a result of these defects, the user could touch live parts during normal use. The product does not comply with the requirements of the Low Voltage Directive and the relevant European standard EN 60598.

The internal earth lead is not adequately attached to the body, resulting in inadequate protection from electric shock. The product does not comply with the requirements of the Low Voltage Directive and the relevant European standard EN 60335.

Internal wires are are only soldered and not attached mechanically. The windings on the transformer are touching. The metal parts of the bulb may become live as a consequence, leading to the user receiving an electrical shock if the bulb is touched. The product does not comply with the requirements of the Low Voltage Directive and the relevant European standards EN 62560 and EN 62471.

The pins of the built-in plug and plug adapter do not have an insulating collar. The plug adapter allows single-pole insertion of a plug, leaving the remaining free live pin accessible. The cover for the LED can be removed by hand during charging, leaving live parts accessible. The cross-sectional area of the core of the wires is insufficient: in case of a short circuit the wires may overheat and can cause a fire. The heat and flame resistance of the insulating material that hold the pins of the built-in plug in position is insufficient.

The basic insulated internal wires of the head torch can be damaged by the sharp edges of the cover fixing screws during adjustment of the head torch. The dimensions of the battery charger are not correct and when connecting the plug the user may consequently touch the live parts of the plug or the live connector terminal sockets. The cross-sectional area of the core of the wires is insufficient: in case of a short circuit the wires may overheat.

The pins of the built-in plug and plug adapter do not have an insulating collar. The plug adapter allows single-pole insertion of a plug, leaving the remaining free live pin accessible. The cover for the LEDs can be removed by hand during charging, leaving live parts accessible. The cross-sectional area of the core of the wires is insufficient: in case of a short circuit the wires may overheat and can cause a fire. The heat and flame resistance of the insulating material that hold the pins of the built-in plug in position is insufficient.

There is insufficient protection against accidental contact with live parts. The user can touch the live lamp cap during insertion. The product does not comply with the Low Voltage Directive and the relevant European standard EN 60238.

The cross-sectional area of the core of the wires is insufficient: in case of a short circuit the wires may overheat and cause a fire. Also, live parts can be touched when connecting the mains lead, since the dimensions of the plug are not suitable, and the protective cover for the LEDs can be removed by hand during charging leaving live parts accessible. In addition, the storage compartment has sharp edges which can damage the insulation of the mains lead. The product does not comply with the requirements of the Low Voltage Directive and the relevant European standard EN 60598.

The cable inside the lamp was twisted during assembly and therefore may have been damaged. The damaged cable can come into contact with the metallic body of the lamp which could consequently become live. The product does not comply with the requirements of the Low Voltage Directive.